Design Considerations - Quectel SC262R Series Hardware Design

3.20.1. Design Considerations

⚫
Special attention should be paid to the pin definition of LCM/camera connectors. Make sure the
module and the connectors are correctly connected.
⚫
MIPI are high speed signal lines, supporting maximum data rate of up to 2.1 Gbps. The differential
impedance should be controlled to 100 Ω. Additionally, it is recommended to route the trace on the
inner layer of PCB, and do not cross it with other traces. For the same group of DSI or CSI signals,
keep all the MIPI traces of the same length. In order to avoid crosstalk, keep a distance of 1.5 times
the trace width among MIPI signal lines. During impedance matching, do not connect GND on
different planes to ensure impedance consistency.
⚫
It is recommended to select a low-capacitance TVS for ESD protection and the recommended
parasitic capacitance should be below 1 pF.
⚫
Route MIPI traces according to the following rules:
a) The total trace length should not exceed 305 mm;
b) Control the differential impedance to 100 Ω ±10 %;
c) Control intra-lane length difference within 0.67 mm;
d) Control inter-lane length difference within 1.3 mm.
Table 23: MIPI Trace Length Inside the Module
Pin Name Pin No.
52 DSI_CLK_N
53 DSI_CLK_P
54 DSI_LN0_N
55 DSI_LN0_P
56 DSI_LN1_N
57 DSI_LN1_P
58 DSI_LN2_N
59 DSI_LN2_P
60 DSI_LN3_N
61 DSI_LN3_P
63 CSI1_CLK_N
64 CSI1_CLK_P
SC262R_Series_Hardware_Design
Length (mm)
12.40
12.40
11.75
11.65
9.40
9.30
9.60
9.60
12.35
12.35
18.10
18.05
Smart Module Series
Length Difference (P - N)
0.00
-0.10
-0.10
0.00
0.00
-0.05
64 / 115