Table of Contents
Advertisement
4
Application Interfaces
4.1. Analog Audio Interfaces
The module provides one analog audio input channel and one analog audio output channel. The pin
definitions are shown in the following table.
Table 9: Pin Definition of Analog Audio Interfaces
Pin Name
MIC_N
MICBIAS
SPK_P
SPK_N
MIC_P
⚫
AI channels are differential input channels, which can be applied for input of microphone (usually an
electret microphone is used).
⚫
AO channels are differential output channels, which can be applied for output receiver.
⚫
The module's internal audio amplifier is configured as a class AB amplifier by default.
4.1.1. Audio Interfaces Design Considerations
It is recommended to use the electret microphone with dual built-in capacitors (e.g., 10 pF and 33 pF) for
filtering out RF interference, thus reducing TDD noise. The 33 pF capacitor is applied for filtering out RF
interference when the module is transmitting at EGSM900. Without placing this capacitor, TDD noise
could be heard. The 10 pF capacitor here is used for filtering out RF interference at DCS1800. Note that
the resonant frequency point of a capacitor largely depends on the material and production technique.
Therefore, you would have to discuss with your capacitor vendors to choose the most suitable capacitor
for filtering out high-frequency noises.
The filter capacitors on the PCB board should be placed as close to the audio devices or audio interfaces
EG915U_Series_Hardware_Design
Pin No.
I/O
119
AI
120
PO
121
AO
122
AO
126
AI
LTE Standard Module Series
Description
Microphone analog input (-)
Bias voltage output for microphone
Analog audio differential output (+)
Analog audio differential output (-)
Microphone analog input (+)
38 / 81
Advertisement
Table of Contents
