Table of Contents
Advertisement
Mounting
6.1
Unpacking
Remove and dispose of the packaging material and transport equipment in compliance with
regulations.
6.2
General information on installation
Working under load
Under load, the system can start or reverse in an uncontrolled fashion.
The entire system must be load-free so that there is no danger when carrying out this work.
NOTICE
Overheating caused by solar radiation
Overheating of the motor due to exposure to direct sunlight
Provide suitable protective equipment such as covers or roofs. Prevent heat accumulation.
NOTICE
Malfunction resulting from foreign objects
The operator must ensure that no foreign objects impair the function of the motor.
Note
Use headless screws of strength class 8.8 or higher to fasten the motor.
Exercise particular care during mounting and installation. The manufacturer cannot be held
liable for damage caused by incorrect mounting and installation.
Make sure that there is sufficient space around the motor for mounting, maintenance and
repair.
On geared motors with a fan, leave sufficient free space for the entry of air. Observe the
installation conditions for the geared motor.
Provide sufficient lifting gear at the start of mounting and fitting work.
Use all the fastening means that have been assigned to the particular mounting position and
mounting type.
Cap screws cannot be used in some cases due to a lack of space. In such cases, please
contact Technical Support, specifying the type of gearbox.
Motors for mounting onto SIMOGEAR gearboxes
Operating Instructions, 01/2024, A5E53220841A/RS-AA
WARNING
6
67
Advertisement
Table of Contents
