Machines With Type Of Construction Im B15, Im B9, Im V8 And Im V9; Foot Mounting - Siemens 1FP1/3 Operating Instructions Manual

Assembly
5.3 Installing the machine
5.3.3

Machines with type of construction IM B15, IM B9, IM V8 and IM V9

Types of construction without bearings on the drive side
These machines do not have their own bearing system for the machine shaft at the drive end
(DE). The machine shaft is accepted by the (hollow) shaft or coupling of the system or driven
machine.
• Using the centering edge, the machine is aligned with respect to enclosures, flanges or
driven machines.
• Note that the temperature of the motor and motor shaft increases during operation. The
thermal expansion of the machine shaft must be compensated by the customer by applying
suitable measures.
Use the spring washers provided to locate the NDE bearing without any play.
NOTICE
Damage to the motor
Material damage can occur if the following notes are not carefully observed:
• The IM B3 bearing shield with integrated distance ring mounted at the drive end (DE) is only
• The spacer ring is not a roller bearing.
• Remove the bearing shield and the spacer ring.
• Remove the transport lock before commissioning.
5.3.4

Foot mounting

Note
Only authorized retrofit partners must be employed to relocate the bolted-on mounting feet at
the machine enclosure.
After attaching the mounting feet, you must note the following in order to avoid stressing
and deforming the machine.
• Ensure that the foot mounting surfaces are aligned in one plane and are parallel to the
machine shaft.
• Post-machine the foot mounting surfaces or use thin shims, for example.
• Professionally touch up damaged painted surfaces.
• Observe the information provided in Chapter Aligning and mounting (Page 55)
54
used transport lock. A warning label is attached to this bearing shield.
1LE1, 1FP1/3, 1PC1/3 shaft height 63 ... 315
Operating Instructions, 11/2023, A5E38483075A