Installation; Figure 2: 7705Eo-Hd Rear Panel - evertz 7700 Manual

7700 MultiFrame Manual
7705EO-HD SMPTE292M Re-Clocking Electrical to Fiber Converter
2.

INSTALLATION

The 7705EO-HD comes with a companion rear plate that has three BNC connectors and one SC/PC
(shown), ST/PC or FC/PC optical connector. For information on mounting the rear plate and inserting the
module into the frame see the 7700FR chapter section 3.
HD INPUT Input BNC connector for 10-bit serial digital video signals compatible with the SMPTE 292M
standard.
(19.4 Mb/s), SMPTE 259M (143 to 540 Mb/s) or DVB-ASI, or most other signals with bit rate
less than 1.5 Gb/s. See section 5.1 for information on operating the module in non-reclock
mode.
HD OUTPUT There are two BNC connectors with reclocked serial component video outputs, compatible
with the SMPTE 292M standard. In non-reclock mode these outputs contain an equalized copy
of the input signal.
There is one SC/PC (shown) ST/PC or FC/PC female connector with reclocked serial
component video outputs, compatible with the SMPTE 292M standard. This connector is the
optical output from the 7705EO-HD as shown in section 3.3.
7705EO-HD-2

Figure 2: 7705EO-HD Rear Panel

The 7705EO-HD can also be used in non-reclock mode with SMPTE 310M
Revision 1.7