Safety And Emc Instructions; Transportation And Storage; Preparation; Installation - Njoy Garun 30KL User Manual

WARNING
Please comply with all warnings and operating instructions in this manual.
This equipment should only be installed, serviced, and maintained by
qualified personnel. If you are the beneficiary of this UPS and you encounter
any problem with it, please contact authorized personel who installed the
UPS. Do not operate this unit before reading through all safety information
and operating instructions carefully.
We assume no responsibility or liability for loss or damages, whether direct,
indirect, consequential or incidental, which might arise out of the use of such
information. The use of any such information will be entirely at the user's risk.
Information in this manual is subject to change without notice. We make no
commitment to update or keep current the information in this manual. If you
find information in this manual that is incorrect, misleading, or incomplete, we
would appreciate your comments and suggestions.
DANGER!
This UPS carries lethal voltages. Installation, maintenance, service and repairs
must be performed by authorized personnel only. There are no user-serviceable
parts inside the UPS. Do not attempt to modify any settings of the UPS unless
you are a trained technician. If you need to change any settings of this UPS or
you have technical warnings or faults shown on UPS screen, please contact the
technician that installed the UPS.
4
1

Safety and EMC instructions

All safety instructions in this document must be read, understood and
followed.

1.1. Transportation and storage

• Please transport the UPS system only in the original packaging to protect
against shock and damage.
• The UPS must be stored in the room where the temperature is well
regulated. Ambient temperature should not exceed 40°C.

1.2. Preparation

• Condensation may form if the UPS system is moved from cold to warm
environment immediately.
• The UPS system must be absolutely dry before being installed.
Please allow at least two hours for the UPS system to acclimate with the
environment.
• Do not install the UPS system near water or in moist environments.
• Do not install the UPS system where it would be exposed to direct
sunlight or near by heat source.
• Do not block ventilation holes on the UPS housing.

1.3. Installation

• Do not connect appliances or devices which would overload the UPS (e.g.
big motor type equipment) to the UPS output terminal.
• Place cables in such a way that no one can step on or trip over them.
• Do not block air vents on the housing of the UPS. Ensure proper unit
spacing of ventilation.
• UPS equipped with grounding terminal, in the final installation phase,
connect grounding/earthing wire to the external UPS battery cabinets or
appropriate grounding terminals
• The UPS can be installed only by qualified maintenance personnel.
• An appropriate disconnect device such as short circuit backup protection
should be incorporated during installation.
• An integral emergency shutoff switch which prevents additional load
from the UPS in any mode of operation should be implemented during the
installation.
• Secure the grounding/earthing wire before connecting to any live wire
terminal.
• Installation and Wiring must be in accordance with the local electrical
laws and regulations.
5