Table of Contents
Advertisement
1
Safety and EMC instructions
All safety instructions in this document must be read, understood and
followed.
1.1. Transportation and storage
• Please transport the UPS system only in the original packaging to protect
against shock and damage.
• The UPS must be stored in the room where the temperature is well
regulated. Ambient temperature should not exceed 40°C.
1.2. Preparation
• Condensation may form if the UPS system is moved from cold to warm
environment immediately.
• The UPS system must be absolutely dry before being installed.
Please allow at least two hours for the UPS system to acclimate with the
environment.
• Do not install the UPS system near water or in moist environments.
• Do not install the UPS system where it would be exposed to direct
sunlight or near by heat source.
• Do not block ventilation holes on the UPS housing.
1.3. Installation
• Do not connect appliances or devices which would overload the UPS (e.g.
big motor type equipment) to the UPS output terminal.
• Place cables in such a way that no one can step on or trip over them.
• Do not block air vents on the housing of the UPS. Ensure proper unit
spacing of ventilation.
• UPS equipped with grounding terminal, in the final installation phase,
connect grounding/earthing wire to the external UPS battery cabinets or
appropriate grounding terminals
• The UPS can be installed only by qualified maintenance personnel.
• An appropriate disconnect device such as short circuit backup protection
should be incorporated during installation.
• An integral emergency shutoff switch which prevents additional load
from the UPS in any mode of operation should be implemented during the
installation.
• Secure the grounding/earthing wire before connecting to any live wire
terminal.
• Installation and Wiring must be in accordance with the local electrical
laws and regulations.
5
Advertisement
Table of Contents
