Safety And Emc Instructions; Transportation And Storage; Preparation; Installation - Njoy Garun Series User Manual

WARNING
Please comply with all warnings and operating instructions in
this manual. This equipment should only be installed, serviced,
and maintained by qualified personnel. Do not operate this unit
before reading through all safety information and operating
instructions carefully.
We assume no responsibility or liability for loss or damages, whether direct, indirect,
consequential or incidental, which might arise out of the use of such information.
The use of any such information will be entirely at the user's risk. Information in this
manual is subject to change without notice. We make no commitment to update or
keep current the information in this manual. If you find information in this manual
that is incorrect, misleading, or incomplete, we would appreciate your comments
and suggestions.
4
1

Safety and EMC instructions

All safety instructions in this document must be read, understood and
followed.

1.1. Transportation and storage

• Please transport the UPS system only in the original packaging to protect
against shock and damage.
• The UPS must be stored in the room where the temperature is well
regulated. Ambient temperature should not exceed 40°C.

1.2. Preparation

• Condensation may from if the UPS system is moved from cold to warm
environment immediately.
• The UPS system must be absolutely dry before being installed. Please
allow at least two hours for the UPS system to acclimate the environment.
• Do not install the UPS system near water or in moist environments.
• Do not install the UPS system where it would be exposed to direct
sunlight or near by heat source.
• Do not block ventilation holes on the UPS housing.

1.3. Installation

• Do not connect appliances or devices which would overload the UPS (e.g.
big motor type equipment) to the UPS output terminal.
• Place cables in such a way that no one can step on or trip over them.
• Do not block air vents on the housing of the UPS. Ensure proper unit
spacing of ventilation.
• UPS equipped with grounding terminal, in the final installation phase,
connect grounding/earthing wire to the external UPS battery cabinets or
appropriate grounding terminals
• The UPS can be installed only by qualified maintenance personnel.
• An appropriate disconnect device such as short circuit backup protection
should be in corporated during installation.
• An integral emergency shutoff switch which prevents additional load
from the UPS in any mode of operation should be implemented during the
installation.
• Secure the grounding/earthing wire before connecting to any live wire
terminal.
• Installation and Wiring must be in accordance with the local electrical
laws and regulations.
5