Chapter 1: Overview; Table 1-1: Acs100 Model Numbering System - Aerotech ACS Hardware Manual

ACS Hardware Manual

Chapter 1: Overview

Table 1-1: ACS100 Model Numbering System
ACS Mechanical-Bearing Direct-Drive Rotary Collet Stage, 100 mm diameter
Stage Size (Required)
-85
-135
Chuck Style (Required)
-ER8
-ER8MB
Feedback (Required)
-E1
-E2
-E3
-E4
-E5
NOTE: Digital output encoder signals are synthesized with a 16 MHz clock. Ensure that the encoder sample rate on the controller is
at least 16 MHz or higher (slower clock rates are available on request).
Rear Seal (Optional)
-SL
Connector (Required)
-CN1
-CN2
Wrench (Optional)
-WR
Air Purge (Optional)
-PR
Metrology (Required)
-PL1
-PL2
Accessories (To be Ordered as a Separate Line Item)
Collet-ER8-CLTxx
Collet-ER8MB-CLTxx
CGF
www.aerotech.com
85 mm stage height; 0.6 N·m continuous torque
135 mm stage height; 1.6 N·m continuous torque
ER8 ultra-precision collet
ER8 microbore collet
Incremental encoder, 1 Vpp, sine wave output
Incremental encoder, TTL, x5 interpolation
Incremental encoder, TTL, x10 interpolation
Incremental encoder, TTL, x25 interpolation
Incremental encoder, TTL, x50 interpolation
Rear seal
4-pin high-powered D-style motor and 25-pin D-style feedback connectors
25-pin D-style motor and 25-pin D-style feedback connectors
Wrench for changing collet
Air purge fitting to positive pressurize ACS stage to limit ingress of airborne
particulates
Metrology, uncalibrated with performance plots
Metrology, calibrated (HALAR) with performance plots
ER8 DIN6499AA electropolished collet, 0.5 mm to 5 mm part sizes diameter
available
ER8 DIN6499AA electropolished mircro-bore collet, 0.2 mm to 0.9 mm part sizes
diameter available
Collet and gripper filtration kit
Chapter 1
Overview
9