Table 1-2: Acs150 Model Numbering System - Aerotech ACS Hardware Manual

Overview
Table 1-2: ACS150 Model Numbering System
ACS Mechanical-Bearing Direct-Drive Rotary Collet Stage, 150 mm diameter
Stage Size (Required)
-115
-135
-180
Chuck Style (Required)
-ER25
-ER40
-3J1
-3J2
-3J3
-3J4
Feedback (Required)
-E1
-E2
-E3
-E4
-E5
NOTE: Digital output encoder signals are synthesized with a 16 MHz clock. Ensure that the encoder sample rate on the controller is
at least 16 MHz or higher (slower clock rates are available on request).
Rear Seal (Optional)
-SL
Wrench (Optional)
-WR
Metrology (Required)
-PL1
-PL2
Accessories (To be Ordered as a Separate Line Item)
Collet-ER25-CLTxx
Collet-ER40-CLTxx
CGF
NOTE: ER40 collet sizes less than 15.5 mm diameter are not supported. Use the ER25 collect chuck if these sizes are required.
10
115 mm stage height; 2.9 N·m continuous torque
135 mm stage height; 5.1 N·m continuous torque
185 mm stage height; 9.3 N·m continuous torque
ER25 ultra-precision collet
ER40 ultra-precision collet
3-Jaw gripper, 10 mm stroke, normally closed
3-Jaw gripper, 10 mm stroke, normally open
3-Jaw gripper, 16 mm stroke, normally closed
3-Jaw gripper, 16 mm stroke, normally open
Incremental encoder, 1 Vpp, sine wave output
Incremental encoder, TTL, x5 interpolation
Incremental encoder, TTL, x10 interpolation
Incremental encoder, TTL, x25 interpolation
Incremental encoder, TTL, x50 interpolation
Rear seal
Wrench for changing collet
Metrology, uncalibrated with performance plots
Metrology, calibrated (HALAR) with performance plots
ER25 DIN6499AA electropolished collet, 0.5 mm to 15 mm part holding sizes
available
ER40 DIN6499AA electropolished collet, 15.5 mm to 25 mm part holding sizes
available
Collet and gripper filtration kit
Chapter 1
ACS Hardware Manual
www.aerotech.com