Table of Contents
Advertisement
SuperStorage 6029P-E1CR16T User's Manual
PCI Expansion Card Installation
The 6029P-E1CR16T can accommodate up to seven low-profile add-on cards in the PCI
expansion slots on the serverboard.
Installing Add-on Card
1. Begin by removing the shield for the PCI slot you wish to populate. Make sure that the
card you are installing is supported by the slot (see table below).
2. Fully seat the card into the slot, pushing down with your thumbs evenly on both sides of
the card.
3. Finish by using a screw to secure the top of the card shield to the chassis. The PCI
slot shields protect the serverboard and its components from EMI and aid in proper
ventilation, so make sure there is always a shield covering each unused slot..
Motherboard Battery
The motherboard uses non-volatile memory to retain system information when system power
is removed. This memory is powered by a lithium battery residing on the motherboard.
Replacing the Battery
Begin by removing power from the system as described in Section 3.1 and removing the
cover as described in Section 3.2.
1. Push aside the small clamp that covers the edge of the battery. When the battery is
released, lift it out of the holder.
2. To insert a new battery, slide one edge under the lip of the holder with the positive (+)
side facing up. Then push the other side down until the clamp snaps over it.
Note: Handle used batteries carefully. Do not damage the battery in any way; a damaged
battery may release hazardous materials into the environment. Do not discard a used battery
in the garbage or a public landfill. Please comply with the regulations set up by your local
hazardous waste management agency to dispose of your used battery properly.
Warning: There is a danger of explosion if the onboard battery is installed upside down (which
reverses its polarities). This battery must be replaced only with the same or an equivalent type
recommended by the manufacturer (CR2032).
Figure 3-3. Installing the Onboard Battery
39
OR
Advertisement
Table of Contents
