Table of Contents
Advertisement
SuperStorage 1029P-NMR36L/LR User's Manual
DIMM Module Removal
Press the release tabs on both ends of the DIMM socket to release the DIMM module from
the socket as shown in the drawing on the right.
Warning! 1. T to avoid damage to the DIMM module or the DIMM socket, do not use exces-
sive force when pressing the release tabs on the ends of the DIMM socket. 2. Handle DIMM
modules with care. Carefully follow all the instructions given in Section 1 of this user guide to
avoid ESD-related damage to your components or system. 3. All graphics, including the layout
drawing above, are for reference only. Your system components may or may not look the same
as shown in this user guide.
PCI Expansion Card Installation
The system includes three pre-installed riser cards (RSC-R1UU-E8R+, RSC-X-6 and
RSC-X-66) that allow you to position standard size PCI-E cards at a 90-degree angle, allowing
them to fit inside the chassis.
Installing PCI Expansion Cards
The riser cards have already been pre-installed into the motherboard. Perform the following
steps to install an add-on card into one of them:
Begin by removing power from the system as described in section 3.1.
1. Remove the chassis cover to access the inside of the system.
2. Remove Riser Card bracket by following illustration on the bracket.
3. Insert the expansion (add-on) card into the riser card.
4. Install Riser Card bracket back to chassis and re-install top cover.
39
Advertisement
Table of Contents
