Supermicro SuperStorage 6029P-E1CR16T User Manual page 54

SuperStorage 6029P-E1CR16T User's Manual
TPM Header
The JTPM1 header is used to connect a Trusted Platform Module (TPM)/Port 80, which is
available from a third-party vendor. A TPM/Port 80 connector is a security device that supports
encryption and authentication in hard drives. It allows the motherboard to deny access if the
TPM associated with the hard drive is not installed in the system. See the layout below for
the location of the TPM header..
Speaker Header
A speaker header is located on JD1. Close pins 1-2 of JD1 to use the onboard speaker.
4-pin BMC External I
A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate
cable here to use the IPMB I
definitions.
Chassis Intrusion
A Chassis Intrusion header is located at JL1 on the motherboard. Attach the appropriate cable
from the chassis to inform you of a chassis intrusion when the chassis is opened.
Trusted Platform Module Header
Pin Definitions
Pin# Definition
1 +3.3V
3 RESET#
5 SPI_CLK
7 SPI_MOSI
9 +3.3V Stby
C Header
2
C connection on your system. Refer to the table below for pin
2
External I
2
Pin Definitions
Pin# Definition
1 Data
2 Ground
3 Clock
4 No Connection
Chassis Intrusion
Pin Definitions
Pin# Definition
1 Intrusion Input
2 Ground
54
Pin# Definition
2 SPI_CS#
4 SPI_MISO
6 GND
8
10 SPI_IRQ#
C Header