Table of Contents
Advertisement
Drive Carrier LEDs
The chassis includes externally accessible SAS/SATA/NVMe drives. Each drive carrier
displays two status LEDs on the front of the carrier.
LED Color
Activity LED
Blue
Blue
Status LED
Red
Red
Red
Red
Red
Green
Amber
PCI Expansion Card Installation
The system provides three PCI slots for low profile, full-length expansion cards.
Installing an Expansion Cards
1. Power down the system, and remove both covers, as described previously in this
section.
2. In the rear of the chassis, remove the screw securing the PCI slot shield in the PCI slot
that you wish to use.
3. Slide the expansion card bracket into the open PCI slot while plugging the expansion
card into the motherboard.
4. Secure the expansion card bracket into the PCI slot using the screw previously set
aside.
5. Replace the top covers and power up the system.
Chapter 3: Maintenance and Component Installation
State
Solid On
Blinking
Solid On
Blinking at 1 Hz
Blinking with two blinks and
one stop at 1 Hz
On for five seconds, then off
Blinking at 4 Hz
Solid On
Blinking at 1 Hz
Figure 3-11. Removing the PCI Slot Shield
50
Status
SAS/NVMe drive installed
I/O activity
Failed drive for SAS/SATA/NVMe with RSTe support
Rebuild drive for SAS/SATA/NVMe with RSTe support
Hot spare for SAS/SATA/NVMe with RSTe support
Power on for SAS/SATA/NVMe with RSTe support
Identify drive for SAS/SATA/NVMe with RSTe support
Safe to remove NVMe device
Attention state—do not remove NVMe device
Advertisement
Table of Contents
