Table of Contents
Advertisement
After installing the chassis tray and individual trays, the internal hot-swappable hard drives
may be removed without powering down the system.
Removing Internal Hard Drives from the Chassis Tray
1. Confirm that that chassis tray and individual trays have been installed as directed in the
previous section.
2. With the power running, remove the middle top cover as described in Section 6-3.
3. Lift the latch on the individual tray and slide the hard drive out toward the front of the
chassis.
Installing Hard Drives Into the Individual Trays
1. After removing the middle top cover and lifting the individual tray latch, insert a hard
drive into the individual tray by sliding it toward the rear of the tray.
2. Close the latch and replace the middle top cover.
Chapter 3: Maintenance and Component Installation
46
Advertisement
Table of Contents
