Quick Start Guide; Added Quick Start Guide Section; Deleted Figure 3; Renumbered Sequentially - Analog Devices ADF4002 User Manual

Evaluation Board User Guide

QUICK START GUIDE

Follow these steps to quickly evaluate the
1. Solder the VCO (T-package compatible).
2. Solder the loop filter components (design with ADIsimPLL™).
3. Connect the reference frequency to J11.
4. Install the system development platform (SDP) drivers.
5. Install the Int-N software.
6. Connect the SDP-S motherboard to the PC and to the EV-ADF4002SD1Z.
7. Follow the hardware driver installation procedure.
8. Connect the power supplies to banana connectors (6 V to 12 V).
9. Run the Int-N software.
10. Select the SDP board and the
11. Click the Main Controls tab. Update all registers.
12. Connect the spectrum analyzer to J2.
13. Measure the results.
ADF4002 device:
ADF4002 device in the Select Device and Connection tab of the software front panel window.
Rev. A | Page 3 of 24
UG-108