Quick Start Guide - Analog Devices EVAL-AD4858FMCZ User Manual

User Guide

QUICK START GUIDE

1. Download and install the ACE Software tool from the
download page, as per the
ware section. If ACE is already installed, make sure you have
the latest version by using Check For Updates option in the
ACE sidebar, as shown in
Figure 2. Check For Updates Option in the ACE Sidebar
2. Run the ACE software and select Plug-in Manager from the
ACE sidebar to install the board plug-in that supports the
product evaluation board and select Available Packages, as
shown in Figure 3. You can use the search field to help filter the
list of boards to find the relevant one. An ACE quickstart guide
is available here at ACE Quickstart - Using ACE and Installing
Plug-ins.
Figure 3. Plug-in Manager Option in the Sidebar
analog.com
ACE
Installing the ACE Evaluation Soft-
Figure 2.
3. Insert the SD card into the SD card slot on the underside of
the ZedBoard. If there is a need to reimage or create a new
SD card, instructions are available at the following website:
Kuiper Linux with support for ACE
4. Ensure the ZedBoard boot configuration jumpers are set to use
the SD card as shown in Figure
ensure the VADJ SELECT jumper is set to the correct voltage
for the EVAL-AD4858FMCZ.
Figure 4. ZedBoard Boot Configuration Jumpers
5. Connect the AD4858 evaluation board to the FMC connector on
the ZedBoard.
6. Connect the USB cable from the PC to the J13/USB OTG port,
and connect the 12 V power supply to J20/DC input.
7. Slide the SW8/POWER switch in the ZedBoard to the on
position. The green LD13/POWER LED turns on and is followed
by the blue LD12/DONE LED (within the ZedBoard). The DS1
LED in the EVAL-AD4858FMCZ will also turn on.
8. The red LD7 LED blinks approximately 20 to 30 seconds later,
indicating the boot process is complete.
9. Launch the ACE software from the Analog Devices folder in
the Windows Start menu. The evaluation board appears on the
ACE Start tab in the Attached Hardware view.
EVAL-AD4858
ADI
Evaluation.
4. To avoid potential damage,
Rev. 0 | 3 of 14