Quick Start Guide - Analog Devices EVAL-AD7928SDZ User Manual

EVAL-AD7928SDZ User Guide

QUICK START GUIDE

Follow these steps to quickly evaluate the
detailed instructions, see the subsequent sections.
1. Install the evaluation software from the
or from the included CD. Ensure that the
SDP board is disconnected from the USB port of the PC
while installing the software. (The PC may need to be
restarted after the installation.)
2. Ensure that the various link options are configured as
outlined in Table 2.
3. Connect the EVAL-SDP-CB1Z
evaluation board as shown in Figure 2. Screw the two
AD7606 ADC. For
AD7606 product page
EVAL-SDP-CB1Z
SDP board to the
Figure 2. Evaluation Board (Left) Connected to the SDP Board (Right)
Rev. PR.A | Page 3 of 13
boards together using the enclosed nylon screw/nut set to
ensure that the boards connect firmly together.
4. Connect a 5V power supply to J1 and ensure LK1 is in
position A.
5. Connect the EVAL-SDP-CB1Z
the USB cable. Choose to automatically search for the
drivers for the SDP board if prompted by the operating
system.
6. Launch the evaluation software from the Analog Devices
subfolder in the Programs menu.
7. Connect an input signal via V1-8.
SDP board to the PC via