Section 5 Troubleshooting; Troubleshooting Guide; Table 5-1 Troubleshooting The Positioner - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

Section 5
This section describes troubleshooting of the system. Do not open the positioner. Opening
the positioner will break the environmental seal and potentially cause improper stop limit
settings. This will void the warranty. This troubleshooting guide assumes:
•
Use of (1) positioner, either PI-35, PI-75 or PI-150.
•
Use of (1) default joystick controller (P/N: 5098901)

5.1 Troubleshooting Guide

This section covers troubleshooting as follows:
•
Positioner (Table 5-1)
•
Controller (Table 5-2)
Symptoms
Positioner Does Not Pan or Tilt
Positioner does not pan
or tilt in a single
direction.
Positioner does not pan
or tilt in multiple
directions.
Positioner Pans or Tilts Improperly
Positioner pans or tilts in
the wrong direction.
PM-01011-A
October 2023
Troubleshooting

Table 5-1 Troubleshooting the Positioner

Possible Cause
An electronic limit stop has
been reached.
The system is not
receiving power.
The power supply is
wrong.
System settings are
incorrect.
The controller is in a
menu.
The system wiring is
incorrect.
Wires are broken or
improperly terminated.
The electronic limit stops
have been reset so that
the positioner cannot
move.
The positioner is faulty.
The wiring is incorrect.
The positioner is faulty.
I
OSITION T
P
Remedy
Reset the electronic limit stops
(Section 3.3.8).
Check the schematics (Section
7).
Check the schematics (Section
7).
Reset the factory defaults
(Section 5.2).
Exit the menu.
Check the schematics (Section
7).
Check the wires and connections.
Reset the electronic limit stops
(Section 3.3.8).
Contact the factory.
Check the schematics (Section
7).
Contact the factory.
P
OSITIONERS
5-1