Section 4 Maintenance; Routine Maintenance; Replacement Parts - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

Section 4
This section describes maintenance of the system. Be sure to read and understanding the
entire maintenance procedure before beginning maintenance.

4.1 Routine Maintenance

Maintain the positioner as follows:
•
Visually inspect to ensure the positioner is kept clean.
•
Visually inspect for damage. If damage is apparent, do not use the positioner and
have it serviced prior to use.
•
Inspect to ensure all fixings and fastenings are tight. All fixings and fastenings must
be thoroughly checked for tightness (1) month following installation, and thereafter at
regular (6) month intervals.
•
Inspect to ensure cables are undamaged and properly terminated. Cabling of the
correct type as specified by national and local standards should be used. Cables
should be checked for wear at (6) month intervals and replaced as necessary.
•
Ensure no water can enter the positioner particularly through the connectors. Water
can cause extreme problems with the positioner.

4.2 Replacement Parts

To order spare or replacement parts, refer to the part numbers list in Section 1.6.
PM-01011-A
October 2023
Maintenance
I P
OSITION T OSITIONERS
P
4-1