Figure 2-13 Powered With Vac - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

Hide thumbs

Table Of Contents

Table of Contents

Powered with 120 VAC (50 or 60 Hz) or 240 VAC (50 or 60 Hz):

The positioner runs on 24 VDC and power other than 24 VDC must be converted to 24 VDC

for the positioner. The default joystick controller (P/N: 5098901) comes with its own power

supply for the VAC input which is transformed to 12 VDC.

If the input power supply is VAC, the system will require:

•

A power supply (P/N: 208016) for the positioner

•

The existing joystick cable to power the joystick

If the customer is using AC input power and the power supply (P/N: 208016), the customer is

responsible for installing a plug (customer-supplied) based on their region. The power supply

ships with loose wires to connect to the appropriate customer supplied plug.

Figure 2-13 provides a quick overview of the wiring for a system powered with AC input.

Positioner

Power Supply

2 Amp Fuse

(P/N: 208016)

To wire the positioner using VAC:

1. Connect the 5-pin plug (attached to the power/data cable) to the positioner.

2. Twist the plug to the right to secure the connection.

3. Run the 22 AWG green (data A) and white (data B) wires from the power/data cable

to the controller.

4. Wire the 16 AWG red (power) and black (ground) wires from the power/data cable

and the controller to the positioner power supply. Run a (2) amp slow blow fuse

(customer supplied) inline between the positioner power supply and the positioner

and controller. An optional step down converter can be run between the controller

and the positioner power supply.

PM-01011-A

October 2023

Power

Wires

(Optional)

Default Joystick

Step Down

Converter

(P/N: 5098901)

(P/N: 208017)