Figure 2-8 Pull The Wires Out The Bottom Of The Positioner; Figure 2-9 Secure The Gasket And Removable Plug To The Bottom Egress - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

7. Pull the wires still in the positioner through the hole at the side egress.
8. Reconnect the quick connect between the wires from the positioner and the plug
making sure the gasket is in place.
9. Gently push the wires into the positioner and secure the gasket and removable plug
in place at the bottom of the mounting pedestal (Figure 2-9). If the gasket is not
properly installed, the positioner will leak and become damaged voiding the warranty.

Figure 2-9 Secure the Gasket and Removable Plug to the Bottom Egress

PM-01011-A
October 2023

Figure 2-8 Pull the Wires out the Bottom of the Positioner

I POSITIONERS
OSITION T
P
2-7