I
P
OSITION
T
OSITIONERS
P
3.5 Stowing the Positioner
The customer may desire to adjust preset position [1] before using this function.
To stow the positioner:
1. Perform the pre-operation check (Section 3.1).
2. Press [1].
3. Press [Pre]. The positioner will move to the preset stowed position. When moving to
the stowed position, the positioner will first pan and then tilt. As the positioner nears
the stowed position, it will slow down. If an emergency stop is required as the
positioner is moving to position, move the joystick to cancel out the command. The
system is stowed.
4. Power down the system.
3.6 Transportation
Before transporting the system, the system needs to be secured. Do not transport without
the positioner stowed and secured. It is the responsibility of the customer to properly secure
the payload when transporting the system.
3-12
PM-01011-A
October 2023