Menu Functions - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

I P
OSITION T OSITIONERS
P
Panning and Tilting
When moving the positioner with the joystick, arrows pointing in the direction of the
movement will display in the lower right corner of the LCD screen. The greater the lean of
the joystick, the faster the movement. Viewed from the front, clockwise movement is to the
left, and counterclockwise movement is to the right.
When panning and tilting, the joystick functions as follows:
•
When the joystick is pushed forward, the positioner will tilt forward. An arrow will
appear pointing forward (
•
When joystick is pulled back, the positioner will tilt back. An arrow will appear
pointing back (
•
When the joystick is moved to the right, the positioner will rotate to the right. An arrow
will appear pointing right (
•
When the joystick is moved to the left, the positioner will rotate to the left. An arrow
will appear pointing left (
•
It is possible to simultaneously adjust both the pan and tilt of the positioner by moving
the joystick towards a diagonal. Arrows for both applicable directions will appear on
the LCD screen. For example, when tilting forward and panning right, both an arrow
pointing forward and an arrow pointing right will appear (
The positioner will continue to move in the direction given by the joystick until the joystick is
released or centered, or the positioner reaches one of its limits. Note that the positioner
motor and gearbox assemblies are designed to be stalled when they hit an obstruction, but
that continuous abuse will cause damage.

3.3.6 Menu Functions

The controller has been designed to use the joystick as the primary controller for menu
function.
To access menu functions:
1. Ensure power is on to the system.
2. Press [Menu] for (2) seconds. The Menu screen (Figure 3-5) will appear.
3. Use the joystick to navigate through the menu. The number keys can also be used to
assist in navigating through the menu.
Detailed steps of specific menu functions are listed in Section 3 and Section 5.
3-8
▲
) on the LCD screen.
) on the LCD screen.
▼
►
) on the LCD screen.
◄
) on the LCD screen.
1. Keyboard setup
2. Dome setup
3. Protocol select
4. Exit menu
Figure 3-5 Menu Screen
▲
).
►
PM-01011-A
October 2023