Operation Tools; General Controls; Table 3-1 Tools And Materials Recommended For Operation - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

I P
OSITION T OSITIONERS
P

3.2 Operation Tools

Table 3-1 lists tools and materials recommended for operation

Table 3-1 Tools and Materials Recommended for Operation

Safety Glasses
Hard Hat or Helmet

3.3 General Controls

The information and instructions described in this section are for the default joystick
controller (P/N: 5098901) for the system. Refer to the controller manual for information on
the specific controller with your system. Some functions of the default joystick controller are
not used with the positioner.
The default joystick controller is not designed to handle inclement weather and should be
kept in a protected environment. When the controller is in operation, the LCD screen
backlight will turn on. The keyboard and joystick can be used to access menu functions,
adjust electronic limit stops, and store and recall preset positions.
The front of the positioner can be identified as the side of the positioner opposite the side
egress on the mounting pedestal while the positioner is in the home position. The positioner
ships in the home position.
The positioner is also designed to be used with PC, Laptop, Tablet, etc. via the use of the
GUI however the GUI is primarily used to access configuration functions. Below are the
installation and control instruction for all options.
3-2
Tools and Materials
Safety Gloves Safety Shoes or Combat
Boots
PM-01011-A
October 2023