Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual page 10

I P
OSITION T OSITIONERS
P
Crush Hazard! Do not stand directly beneath the positioner or payload. Be certain payload
is properly installed and secured. In locations or areas where the risk of injury occurs, or any
part of the assembly may become detached or fall for any reason, a strong safety chain or
wire hawser should be attached between the equipment and the mounting surface. At all
times, normal safety precautions must be employed. Death or serious injury could result if
positioner fails suddenly.
Safety Equipment! Helmets or hard hats, eye protection, gloves, and safety shoes or
combat boots must be properly worn while working in the deployment area. Death or serious
injury could result if proper safety equipment is not properly worn.
Trained Personnel Only! Installation, operation, and maintenance to be performed by
trained and authorized personnel only. Death or serious injury could result if proper
installation, inspection, operation, and maintenance procedures are not observed.
Lifting Hazard! Manually lifting over 55 lb. (25kg) is prohibited. All lifting equipment must be
thoroughly examined annually by a competent person.
Safety Instruction – Remote Control! The equipment is subject to remote control and may
be operated at any time. Persons working on the equipment should take appropriate
precautions to ensure that any unexpected movement does not occur as this could lead to
injury.
Equipment Damage! All persons installing and maintaining this equipment should be
suitably qualified and work to national and local standards and codes of practice.
Equipment Damage! Each positioner contains a 1.85 amp self-resetting circuit breaker to
protect the PC board. Do not disassemble the positioner side plates, or separate from the
pedestal. Doing so will break the environmental seal and potentially cause improper stop
limit settings. This will void the warranty.
viii PM-01011-A
October 2023