Mounting The Payload; Figure 2-14 Pi-35 Payload Mounting Hole Pattern; Figure 2-156 Pi-150 Payload Mounting Hole Pattern - Will Burt POSITIONIT MM233TX2TXRX2 Operator's Manual

I P
OSITION T OSITIONERS
P

2.7 Mounting the Payload

This section discusses mounting the payload.
Safety Instruction – Mounting Instructions! Before operation, be certain the positioner is
capable of resisting forces generated from all loading and environmental conditions
including, but not limited to payload size and weight, sail size, and wind and ice loading. The
mounting hardware must include proper means to resist vibration loosening such as thread-
locking compound or locking hardware. Mounting the payload into a positioner unable to
resist the forces generated from the customer-specific loading scenario could result in death
or serious injury, and could damage the positioner.
To attach the payload:
1. Ensure power to the system is off while installing the payload.
2. Reference the mounting hole patterns for the payload:
•

Figure 2-14 PI-35 Payload Mounting Hole Pattern

•
Figure 2-15 PI-75 Payload Mounting Hole Pattern
•

Figure 2-156 PI-150 Payload Mounting Hole Pattern

3. Position the payload on the mounting plate.
4. Connect the payload to the top of the positioner with appropriate hardware. Torque
all hardware as appropriate for its material and size. The mounting hardware must
include proper means to resist vibration loosening such as thread-locking compound,
or locking hardware.
2-12
Figure 2-14 PI-35 Payload Mounting Hole Pattern
PM-01011-A
October 2023