Stowing The Positioner; Transportation - Will Burt POSITIONIT PI-150 Operator's Manual

I PI-150
P OSITION T AND

3.5 Stowing the Positioner

The customer may desire to adjust preset position [1] before using this function.
To stow the positioner:
1. Perform the pre-operation check (Section 3.1).
2. Press [1].
3. Press [Pre]. The positioner will move to the preset stowed position. When moving to the
stowed position, the positioner will first pan and then tilt. As the positioner nears the
stowed position, it will slow down. If an emergency stop is required as the positioner is
moving to position, move the joystick to cancel out the command. The system is stowed.
4. Power down the system.

3.6 Transportation

Before transporting the system, the system needs to be secured. Do not transport without the
positioner stowed and secured. It is the responsibility of the customer to properly secure the
payload when transporting the system.
3-8
PI-75
TP-5129001-J
January 2022