Figure 2-13 Powered With Vac - Will Burt POSITIONIT PI-150 Operator's Manual

Figure 2-13 provides a quick overview of the wiring for a system powered with AC input.
Positioner
Power Supply
2 Amp Fuse
(P/N: 208016)
To wire the positioner using VAC:
1. Reference WD-50610, page 3 of 3 in Section 7.
2. Connect the 5-pin plug (attached to the power/data cable) to the positioner.
3. Twist the plug to the right to secure the connection.
4. Run the 22 AWG green (data A) and white (data B) wires from the power/data cable to
the controller.
5. Wire the 16 AWG red (power) and black (ground) wires from the power/data cable and
the controller to the positioner power supply. Run a (2) amp slow blow fuse (customer
supplied) inline between the positioner power supply and the positioner and controller.
An optional step down converter can be run between the controller and the positioner
power supply.
TP-5129001-J
January 2022
Power
Wires
(Optional)
Default Joystick
Step Down
Controller
Converter
(P/N: 5098901)
(P/N: 208017)

Figure 2-13 Powered with VAC

I PI-150
P OSITION T AND
Power
Wires
Positioner
Control
Wires
PI-75
2-11