Mounting The Drive; Mechanical Outline - Moons' MSSTAC5 Hardware Manual

STAC5 Ethernet Hardware Manual

Mounting the Drive

Use M4 screws to mount your drive. If possible, the drive should be securely fastened to a
smooth, flat metal surface that will help conduct heat away from the chassis. If this is not possible,
then forced airflow from a fan may be required to prevent the drive from overheating.
• Never use your drive in a space where there is no air flow or where other devices cause the
surrounding air to be more than 40°C.
• Never put the drive where it can get wet or where metal or other electrically conductive par-
ticles can get on the circuitry.
• Always provide air flow around the drive. When mounting multiple MSSTAC5 drives near each
other, maintain at least one half inch of space between drives.

Mechanical Outline

Rev. 1.0
05/07/2013
122.5
116
Unit:mm
24
49
38
2-4.5