Table of Contents
Advertisement
Bit 30
Bit 31
8 8 The instructions of Raycus software
8.1 The main menu of the Raycus software display
The main interface of the Raycus software display is shown in Figure 24.
Basic usage method of Raycus laser Raycus software:
a) Click "Mode", select "Control Mode", and click "OK" to enter the control mode;
b) Click "Power on main power OFF" to power on the main power supply of the laser. This button
changes to "Power on main power ON", and the "Power" indicator in the main status bar is lit;
c) Click the red light ON button to turn off the red light and wait for the laser preparation to complete.
After the laser preparation is completed, the "Ready" indicator in the main status bar will be lit;
d) Set "Power [%]" or "Power [W]", set "Frequency" and "Duty Cycle", and click "Set";
e) Click "Laser Emission ON", the laser emits light, and the "Emission" indicator in the main status bar is
lit;
f) If it is necessary to set the output optical power to a ramp up or ramp down mode, you can set the
"Power ramp up time" and "Power ramp down time" in the "Laser" area, and click "Set" to enter the
power ramp up or ramp down mode for the laser;
g) If you need to edit the optical power waveform yourself, you can refer to Section 8.13 of this operating
instruction to edit the waveform, set the "Program Number" in the "Laser" area, enter the programming
mode, and click "Laser Emission ON" to output the laser according to the edited waveform.
Optical circuit safety interlock
normal
Optical circuit safety interlock
abnormal
Normal
High average power
46
Advertisement
Table of Contents
