Raycus RFL-C30000M-CE User Manual page 44

Set Diode Current (%)
The set value must be less than 100% and above
SDC the minimum current setting value, which can be
set to 0. If the set value is greater than 100, the
default is input 100.
Read Current Set point
RCS
RPRR Read Pulse Repetition Rate (Hz)
Read Board Temperature
RBT
RPW Read Pulse Width (ms)
RCT Read Laser Temperature
Reset Errors
PERR
SUT Set Up Time (ms)
SDT Set Down Time (ms)
RUT Read Up Time (ms)
RDT Read Down Time(ms)
PSRT Program Start
PSTP Program Stop
Enable Calibration Mode
–Power linear correction mode (in this mode, the
ECM external analog is corrected and output after
filtering, so the response time of AD analog is
larger than that of through mode)
Send: 'SDC 100\r'
Return: 'SDC：100\r'
Other return values:
'ERR: Input Err\r'
'Laser is worked in AD Mode\r'
Send: 'RCS\r'
Return: 'RCS: 56.7\r'
(The current set value is 56.7 %)
Send: 'RPRR\r'
Return: 'RPRR:10\r'
(Repeat frequency is10Hz)
Send: 'RBT\r'
Return: 'RBT:36.6\r'
Send: 'RPW\r'
Return: 'RPW:5.5\r'
(pulse width is 5.5ms)
Send: 'RCT\r'
Return: 'RCT:34.5\r'
Send: 'PERR\r'
Return: 'PERR\r'
Send: 'SUT 50\r'
Return: 'SUT:50\r'
Send: 'SDT 50\r'
Return: 'SDT:50\r'
Send: 'RUT \r'
Return: 'RUT:50\r'
Send: 'RDT \r'
Return: 'RDT:50\r'
Send: 'PSRT 1\r'
Return: 'PSRT:1\r'
Send: 'PSTP\r'
Return: 'PSTP\r'
Send: 'ECM \r'
Return: 'ECM\r'
43