Table of Contents
Advertisement
Figure 9 Remove the A -type end cap on the optical cable
e) Check the cleanliness of the end caps in this state. If the cleanliness is not enough, please clean
the end caps.
Please refer to the cleaning method: http://www.raycuslaser.com/view/1852.html
Reference video:https://mp. weixin.qq.com/s/hRXrPkb8DAyvDYegSWwYLg .
Note: The end cap cleaning is generally performed by our professional staff. If the
customer needs to operate it by himself, we need to go through the relevant training of our
staff and obtain the relevant qualifications before the above operations can be carried out.
If the operation method is improper, it will cause irreversible and serious damage to the
output optical cable during use.
After ensuring the cleanliness, install the B- type end cap. During the installation process, there
will be resistance when screwed to the bottom, which is a normal phenomenon. It is necessary
to ensure that there is no gap between the end cap and the main body sleeve. And then check the
finish and cleanliness of the end cap's glossy surface, as Figure 9 shown. Then connect the fiber
optic cable output head to the cutting head (or welding head) with the B- type end cap installed.
This operation needs to ensure the cleanliness of the inner and outer surfaces of the cutting head
(or welding head) connector.
Note: The connection with the cutting head (or welding head) still needs to be carried out
in a clean workbench, and it is necessary to check the cleanliness and smoothness of the
relevant components of the cutting head (or welding head) itself.
Keep the corresponding accessories as Figure 10 shown in order to facilitate the re-transportat-
ion of the laser or output cable.
Note: The fiber optic cable must be loaded with Type A end caps each time it is
transported. That is, every time the output optical cable is unloaded from the cutting head
17
Advertisement
Table of Contents
