Table of Contents
Advertisement
f) XP1-C1 is connected to 24V, and the main power is turned on (users can also directly press the
"LASER" button, or clicks the main power "ON" on the Raycus software)
g)
Waiting for "Ready"
h)
The Raycus software sets the power, XP1-A2 is connected to 24V, and the control board card
outputs MOD signal
6.7 Programming Mode in REM Mode
Figure 22 Wiring diagram of programming mode in REM Mode
Operations Steps:
a)
Turn the knob switch on the rear panel to"ON"
b)
Turn the key switch to"REM"
c)
Short-circuit pin 8/9 on XP2
d)
XP1-A1 connects to 24V
e)
Connect XP1-A5 to 24V and turn on the guide laser; after checking the optics, connect XP1-A5
to 0V and turn off the guide laser
f) XP1-C1 is connected to 24V, and the main power is turned on (users can also directly press the
"LASER" button, or clicks the main power "ON" on the Raycus software)
g)
Waiting for "Ready"
h)
XP1-(A8-14) select the number of the pre-executed program, set XP1-A2 high to start executing
the program.
40
Advertisement
Table of Contents
