Eaton SPC Max Series Installation Instructions Manual page 18

Instruction Booklet IB158002EN
Effective September 2023
Communication setting changes require a reboot of the
microcontroller to enable it .
Figure 45. Method of IP allocation
IP configuration changes require a reboot of the device
To initiate a soft reset from the web UI, go to the General tab and
click on the down arrow across from Reboot or Reset Device as
shown below .
Figure 46. Click the down arrow
Figure 47. Select Reboot Device
Click OK to verify that you want to continue with this operation . The
LEDs on the display will turn off, then back on again to indicate that
this command has been implemented .
Figure 48. Confirm reboot
18
EATON www.eaton.com
SPC Max Series surge protective device
A pop-up window opens to confirm the reboot .
Figure 49. Click Reload
Modbus and BACnet access
The PX-SPD supports Modbus TCP and BACnet/IP using the
Ethernet port; both are initially disabled . Using Modbus commands,
the PX-SPD can be used to read real-time parameters, events and
logs from the connected SPD . You will need a Modbus TCP capable
application such as ModScan, which acts as the Modbus primary
and the SPD is the Modbus secondary . Refer to Appendix F Modbus
register map for details on available registers and their properties .
Refer to Appendix H for the BACnet register map .
Sensitivity setting
Attention: Eaton does not recommend that the customer modify the
sensitivity setting without first contacting Eaton Customer Support
at 1-800-809-2772 or email SPD@eaton.com . Increasing the
sensitivity setting will reduce the number of low-level surge counts .
How to reset the PX-SPD password
To reset the Power Xpert SPD password through the local
display, the user must first access the concealed menu . To gain
access to the concealed menu, return to the home screen, and
then press the following buttons in order within 5 seconds:
UP, UP, DOWN, DOWN, BACK, BACK, ENTER, ENTER
Follow the screen prompts to reset the password . When this
password reset command is activated, the local display and web UI
passwords are reset to their default values . The Power Xpert SPD
local display prompts the user for a 6-digit numeric password to be
entered before being able to enter the settings menu . The web UI
user name and password returns to default:
User name: admin
Password: Admin*1
End of life disposal
Before disposing of this device, go to Device Actions and select
Reset Device to clear logs of any data .
Installation instructions for