Eaton SPC Max Series Installation Instructions Manual page 12

Instruction Booklet IB158002EN
Effective September 2023
Power Xpert SPD network connection.
Plug one end of a Cat5e Ethernet cable into the SPD and the other
into a laptop or PC . The device comes from the factory with the
default IP address listed below but can also be set up for dynamic
IP (DHCP) or a user-defined static IP address .
Default IP address is: 192 .168 .1 .254
Default user: admin
Default password: Admin*1
Open Google Chrome or Internet Explorer 11 .x or higher and enter
the fixed IP address 192 .168 .1 .254 and then ENTER .
This window will open .
Click Advanced .
12
EATON www.eaton.com
SPC Max Series surge protective device
Click "Proceed to..." near the bottom of the window .
The login screen shown below will open . Enter the default user
name and password shown above and then ENTER .
Figure 20. Power Xpert login screen
The change password window will open . Enter the default pass-
word and then enter a new 6-digit alphanumeric password and then
click OK . Save password in a secure location to access the Web UI .
If lost, contact Eaton's Application Engineers, at 1-800-809-2772, or
email SPD@eaton.com .
Installation instructions for