Power Xpert Spd User Setup - Eaton SPC Max Series Installation Instructions Manual

Instruction Booklet IB158002EN
Effective September 2023

Power Xpert SPD user setup

General
The Eaton Power Xpert SPD (PX-SPD) can be set up using just
the local display or with a laptop or PC, Cat 5e cable, and a web
browser . Modbus, BACnet, and HTTP are initially disabled to provide
cybersecurity protection . Modbus can be enabled through the
LCD module or the web UI . BACnet and HTTP can only be enabled
through the web UI . The PX-SPD must be rebooted after enabling
Modbus or BACnet communications .
Setup using only the local display
Once the SPD has been powered up, the device's home screen will
appear on the local display . See below . The home screen shows the
catalog number of the device, the device's name, the time, and the
firmware version .
Figure 13. Power Xpert home screen
Setting up the date and time
To set the current date and time, press ENTER to go to the
main menu .
Figure 14. Power Xpert main menu
Now scroll down the menu to settings by pressing the down arrow .
The cursor "<" is located to the right of the menu category selection .
Position the cursor to the right of settings < by pressing the DOWN
button twice and then ENTER .
10
EATON www.eaton.com
SPC Max Series surge protective device
Figure 15. Move cursor to settings
Next, enter a 6-digit password by pressing the UP button to the
desired first number . If you go past the number, press the DOWN
button and then ENTER to go to the next digit . Repeat the process
until all 6 digits have been entered . After all 6 digits have been
entered, press ENTER to continue .
Figure 16. Password screen
Next, select the date and time category by pressing ENTER .
Figure 17. Select date and time
Next, press ENTER to edit the date and time, or the BACK button to
exit and return to the previous screen .
Installation instructions for