Installation instructions for
SPC Max Series surge protective device
Figure 18. Setting date and time
Press UP to enter the month and then ENTER to move to the date
selection . Press UP to enter the date and then ENTER . Next, press
UP to scroll to the current year . Press ENTER to move to hours and
repeat the process for minutes and seconds . Lastly, press ENTER
to save the settings and then return to the previous screen .
(Time will initially be displayed in UTC time on the web UI . This
can be changed through the web UI .)
Figure 19. Saving the date and time
Configuration of the user's laptop to communicate to PX-SPD
Follow these steps to enter the IP and Subnet Address on the user's
laptop or PC .
1. In Windows applications, navigate to Network and
Sharing Center .
2. Click Change Adapter Settings .
Instruction Booklet IB158002EN
3. Left click on Ethernet and then right click to open the window
shown below . Then select Properties .
4. Click Internet Protocol Version 4 (TCP/IPv4) .
5. Select Properties .
6. On the General tab, select Use the Following IP Address:
a. Enter 192 .168 .1 .10 for the IP address .
b. Enter 255 .255 .255 .0 for the subnet mask .
c. Enter 192 .168 .1 .1 for default gateway .
7. Click OK and then exit out of all open windows .
Effective September 2023
EATON www.eaton.com
11