Control Panel Description; Control Panel Components; Description Of The Home Screen - REMEHA Gas 320 Ace Installation And User Manual

6 Preparation of commissioning
Fig.77 Check the gas inlet pressure
1
P1
Fig.78 Check and set the VPS dial
2
5/6 7/8/9
VPS
VPS GPS
GPS
3
6.2

Control panel description

6.2.1

Control panel components

Fig.79 Control panel components
3
4
5 6
6.2.2

Description of the home screen

44
1. Check the gas inlet pressure at measuring point P1.
AD-3002127-01
2. Check which pressure is set on the VPS dial.
10
3. Set the VPS dial to 50% of the inlet pressure. The maximum setting is
GPS
VPS
3
AD-3002128-01
2
1
AD-3000932-02
This screen is shown automatically after start-up of the appliance. The
control panel automatically enters standby mode (black screen) if the
buttons are not used for 5 minutes. Press one of the buttons on the control
panel to activate the screen again.
You can navigate from any menu to the home screen by pressing the back
button
The tiles on the home screen provide quick access to the corresponding
menus. Use the rotary knob to navigate to the desired item and press the
button
The VPS is located on the gas control valve.
40 mbar.
1 Rotary knob to select a tile, menu or setting
2 Confirm button
to confirm the selection
3 Back button
:
Short button press: Return to the previous level or previous
menu
Long button press: Return to home screen
4 Menu button
to go to the main menu
5 Display
6 Status LED
for several seconds.
to confirm the selection.
7734324 - v.07 - 21092022