Commissioning; Commissioning Procedure - REMEHA Gas 320 Ace Installation And User Manual

7 Commissioning

Icon Description
The solar calorifier is on and its heat level is displayed.
CH operation is enabled.
CH operation is disabled.
DHW operation is enabled.
DHW operation is disabled.
The burner is on.
The burner is off.
Burner output level (1 to 5 bars, with each bar representing 20% output).
The pump is running.
Three-way valve indicator.
Display of the system water pressure.
Chimney sweep mode is enabled (forced full load or low load for O
Energy-saving mode is enabled.
DHW boost is enabled.
Timer program is enabled: The room temperature is controlled by a timer program.
Manual mode is enabled: The room temperature is set to a fixed setting.
Temporary overwrite of the timer program is enabled: The room temperature is changed temporarily.
The holiday program (including frost protection) is active: The room temperature is reduced during your holiday to
save energy.
Frost protection is enabled: Protect the boiler and installation from freezing in winter.
Installer contact details are displayed or can be filled in.
Bluetooth enabled. When the icon is non-transparent Bluetooth is connected, when the icon is transparent Bluetooth
is disconnected.
Heating enabled.
Cooling enabled.
Heating/cooling enabled.
Heating/cooling disabled.
Tab.47 Icons - Zones
Icon Description
All zones (groups) icon.
Living room icon.
Kitchen icon.
Bedroom icon.
Study icon.
Cellar icon.
7 Commissioning
7.1

Commissioning procedure

46
/CO
2
Warning
Commissioning must be done by a qualified installer.
If adapting to another gas type, the gas valve unit must be
adjusted before switching on the boiler.
1. Open the main gas valve.
2. Open the appliance gas valve.
3. Switch on the power with the boiler's on/off switch.
measurement).
2
7734324 - v.07 - 21092022