Hydraulic Circuit; Electrical Connections; Control Panel Description; Control Panel Components - REMEHA Quinta Ace 30 Installation And User Manual

6.1.4

Hydraulic circuit

6.1.5

Electrical connections

6.2

Control panel description

6.2.1

Control panel components

Fig.41 Control panel components
3
4
5 6
6.2.2

Description of the home screen

7684359 - v.11 - 13122021
4. Check the gas inlet pressure at the measuring point C on the gas
valve unit.
Warning
The gas pressure that was measured at the measuring point C
must fall within the stated gas inlet pressure limits. See
Technical data, page 79
For authorised gas pressures, see: Unit categories, page 76
5. Vent the gas supply pipe by unscrewing the measuring point on the
gas valve unit.
6. Tighten the measuring point again when the pipe has been fully
vented.
7. Check all connections for gas tightness. The maximum allowable test
pressure is 60 mbar.
1. Check the siphon; it should be fully filled with clean water.
2. Check the water-side connections for tightness.
1. Check the electrical connections.
1 Rotary knob to select a tile, menu or setting
2 Confirm button
3 Back button
2 Short button press: Return to the previous level or previous
menu
Long button press: Return to home screen
4 Menu button
1
5 Display
6 Status LED
See also
Additional documentation, page 8
AD-3000932-02
This screen is shown automatically after start-up of the appliance. The
control panel automatically enters standby mode (black screen) if the
buttons are not used for 5 minutes. Press one of the buttons on the control
panel to activate the screen again.
You can navigate from any menu to the home screen by pressing the back
button for several seconds.
The tiles on the home screen provide quick access to the corresponding
menus. Use the rotary knob to navigate to the desired item and press the
button to confirm the selection.
6 Preparation of commissioning
to confirm the selection
:
to go to the main menu
33