How To Find The Desired Installation Example - REMEHA Gas 320 Ace Installation And User Manual

Fig.26 Normal connector
AUX
N L
Fig.27 Combined connector
N L TS TS
Fig.28 Connector to be bridged
R-bus
4.8.2

How to find the desired installation example

Fig.29 Eight sections
1 2 3 4
X 00 00 00
Fig.30 Zone name examples
CircA 1 CircB 1 CircC 1
CircA CircA 1
CircB 1 CircA 1
7734324 - v.07 - 21092022
AUX
N L
AD-3001511-01
N L TS TS
AD-3001512-01
R-bus
AD-3001513-01
5 6 7 8
00 00 00 00
AD-3001527-02
DHW 1 AUX 1
DHW
DHW
AD-3002008-01
These connectors can be connected normally.
These connectors combine two plugs into one connector. In the
installation examples they appear with one highlighted part, which is to be
used.
Row B shows all connectors to be bridged. Connect a bridge to this
connector.
Each example has a code describing the hydraulic set-up. The hydraulic
code consists of eight sections. The first section is a letter, and the
following sections consist of two numbers each:
Tab.20 Meaning of the letter and numbers
Numbers Scheme type H (Hydraulic)
1 Letter for scheme type
2 Number for the producer
3 Number for the connection
4 Number for zone 1
5 Number for zone 2
6 Number for zone 3
7 Number for DHW zone
8 Number for DHW extension
The zones, DHW zone, and DHW extension zone can have different
names, depending on the devices used. A "1" after the zone name means
that the zone is controlled by an expansion PCB, of which the rotary
switch has been set to "1". The zone name is shown on top of the
columns.
The numbers of each section are linked to a specific configuration. Please
see the following tables for the configuration:
4 Before installation
23