Parameters In The "Setup/Gen.serv." Menu - Sartorius Cubis MCE Series Operating Instructions Manual

Operating Design
Parameter Settings
ON Z/T ON*
OFF
ISOCAL ON*
OFF
NOTE
CAL.UNIT GRAMS*
CONF.UNIT
* Factory setting
4.8.2

Parameters in the "SETUP/GEN.SERV." Menu

Parameter Settings
MEN.RESET DEFAULT
NO*
* Factory setting
32 Operating Instructions Cubis
Explanation
Activates the initial taring | zeroing. The device is tared or zeroed after it is
switched on.
Deactivates the initial taring | zeroing: After it is switched on, the device shows
the same value as before it was last switched off.
Activates the isoCAL function. The device is automatically adjusted as soon as a
trigger starts the isoCAL function.
Switches the isoCAL function off. This setting change is not available for all
models.
The [isoCAL] button flashes if the balance needs to be adjusted. The isoCAL
function must be manually triggered with the [Adjust] button.
Changes the calibration weight unit to grams.
Changes the calibration weight unit to milligrams.
Explanation
Resets the system settings to the factory default settings.
Deactivates the option of resetting the device menu.
| MCE Models
®