Positioning The Weighing Pan And Associated Components; Installing The Draft Shield - Sartorius Cubis MCE Series Operating Instructions Manual

5.7 Positioning the Weighing Pan and
Associated Components
Procedure
Insert the base of the weighing compartment (3) into the device.
t
If there is a weighing pan with a shield plate: Place the shield plate (2)
t
onto the pan retainer in the base of the weighing compartment.
Insert the weighing pan (1) into the pan retainer.
t
If the weighing pan needs to be turned, e.g. with sample holders:
t
1
Lift the weighing pan and turn it to the left or right.
t
The weighing pan snaps into the next position of the pan retainer. This
2
y
avoids accidental turning of the weighing pan.
3
5.8

Installing the Draft Shield

Procedure
Procedure
Remove the operating display from the device.
t
Install the upper door. To do this, insert the two door panel mounts into
t
the two guide rods on the side of the device and push backwards.
Install the right and left doors. To do this, insert the door panel mounts,
t
one after the other, into the guide rods at the bottom on the side of the
device, and push backwards.
Operating Instructions Cubis
Installation
| MCE Models 47
®