Installing The Indicator - Emerson Rosemount 8600D Series Reference Manual

Reference Manual
00809-0100-4860, Rev BC
Figure 2-17
Figure 2-17. Optional Liquid Crystal Display
A HART-based communicator can be used to change the engineering units of the parameters
displayed on the indicator.
2.7.1

Installing the indicator

For flowmeters ordered with the LCD indicator, the indicator is shipped installed. When
purchased separately from the Rosemount 8600D, you must install the indicator using a small
instrument screwdriver and the indicator kit (part number 8600-5640). The indicator kit
includes:





Referring to
LCD indicator:
1.
2.
Installation
shows the indicator display with all segments lit.
(SeeSection 4: Operation
One LCD indicator assembly
One extended cover with o-ring installed
One connector
Two mounting screws
Two jumpers
Figure 2-16, use the following steps to install the
If the flowmeter is installed in a loop, secure the loop and disconnect the power.
Remove the flowmeter cover on the electronics side.
Get other manuals https://www.bkmanuals.com
Section 2: Installation
for more information).
January 2013
25