Prepare for installation cont...
( G )
Working inside the loadbay, just below the wheel arches towards the rear of the vehicle, measure and
mark the load bay either side as indicated below. Drill a 6.5mm hole on each of your markings.
760 mm
( H )
Secure the two D-rings (Item 33 received with SSDS201) to the inside of the vehicle's
load bay. You will be bolting through the two 6.5 mm holes drilled in Step 2H using
two M6 x 25 Hex Bolts, four M6 x 19 Flat Washers, two M10 x 50 Flat Washers and a
two M6 Nyloc Nuts (Items 32, 34, 36, 37 received with SSDS201) as shown.
REV_A02
Edge of Load Bay
Outer Rib
130 mm
6
Place, Mark & Drill
6.5mm Hole
Outer Rib