Advertisement
Prepare for installation cont...
(
)
Slide a Channel Nut (Item 13) into each end of the Track (Item 16). Place the Track under the front of the
D
Drawer System and line the Channel Nuts in the Track up with the mounting holes in the front corners of
the Drawer System. Loosely secure the Track to the Drawer System using the two M8 x 16 Hex Bolts, two
M8 x 25 Flat Washers and two M8 Springs Washers (Items 12, 14 15). Center the Track from left to right
and fasten.
(
)
Looking at the rear of the Drawer System, remove the bolts as indicated by the arrows. Keep the bolts and
E
washers safe as they will be used at a later stage.
( F )
Using six M6 x 20 Hex Hex Bolts, six M6 Spring Washers and six M6 x 19 Flat Washers removed in Step 2E,
secure the Rear Support (Item 23) to the back of the Drawer System as shown.
REV_A02
5
Advertisement
