Advertisement
Prepare for installation cont...
(
)
Slide the three Channel Nuts (Item 13) into the Track (Item 16). Place the Track under the front cross strap
D
of the Drawer System. Line the three Channel Nuts inside the Track up with the mounting holes in the
cross strap (as indicated by the arrows) and loosely secure the Track in position using the three M8 x 16
Hex Bolts, three M8 x 25 Flat Washers and three M8 Springs Washers (Items 12, 14, 15). Center the Track
from left to right and fasten.
(
)
Looking at the rear of the Drawer System, remove the bolts as indicated by the arrows. Keep the bolts and
E
washers safe as they will be used at a later stage.
( F )
Using six M6 x 20 Hex Hex Bolts, six M6 Spring Washers and six M6 x 19 Flat Washers removed in Step 2E,
secure the Rear Support (Item 23) to the back of the Drawer System as shown.
REV_A02
5
Advertisement
