Advertisement
Install Drawer System CONT...
(
)
Fit the Side and Rear Decks (Items 28, 29, 30, 31) into position, by "clipping" the outer edge of the Decks
E
into the Wing Sliders (Item 24 & 26) and pushing the Decks towards the outside of the vehicle, thereby ad-
justing the Slider to the correct length. Once you are happy with the length of the Slider, carefully remove
the Decks taking care not to move the Sliders and fasten the two bolts on each Slider, locking it into posi-
tion.
( F )
Secure the center of the Rear Decks to the Rear Support (Item 23) using the two M6 x 25 Countersunk
Bolts and two M6 Finishing Washers (Items 38 & 39).
(
)
Assemble the two Front Faces (Items 40, 41) to the
G
side of the Drawer System using the four M6 x 16 But-
ton Head Bolts, four M6 Flat Washers and four Nyloc
Nuts (Items 32, 42, 43).
4
4
A
REV_A02
9
Advertisement
