Advertisement
Install Drawer System cont...
(
)
Secure the middle D-ring mounts on the Drawer System to the D-rings fitted in Step 2I using a C-hook and
D
Turn Buckle (Items 2, 11) each side. Secure the front D-Ring mounts to the tie down rings found at the
rear of the vehicle using the remaining C-hooks and Turn Buckles. Ensure the Wing Nut goes towards the
top of the Drawer System. When tightening the Turn Buckles ensure that the Drawer System remains cen-
tered left to right and 55 mm from the front. Once the Drawer is secure in position tighten the Wing Nuts
on the Turn Buckles and the Bolts securing the D-rings to the Drawer System and the vehicle's load bay.
(
)
Fit the Side and Rear Decks (Items 28, 29, 30, 31) into position, by "clipping" the outer edge of the Decks
E
into the Wing Sliders (Items 24 & 26) and pushing the Decks towards the outside of the vehicle, thereby
adjusting the Slider to the correct length. Once you are happy with the length of the Slider, carefully re-
move the Decks taking care not to move the Sliders and fasten the two bolts on each Slider, locking it into
position.
( F )
Secure the center of the Rear Decks to the Rear Support (Item 23) using the two M6 x 25 Countersunk
Bolts and two M6 Finishing Washers (Items 37 & 38).
REV_A02
MIDDLE MOUNTINGS
FRONT MOUNTINGS
Ensure Wing
Nut at Top
Ensure Wing
Nut at Top
9
C-Hook
C-Hook
Advertisement
